adjustablebedparts.com
  • Home
  • ADJUSTABLE BED PARTS INDEX
  • IN HOME SERVICE
  • ABOUT US
  • Testimonials
  • Contact Us
  • RETURN POLICY
  • USB PORTS
760.773.2337

Copyright 2011-2026 All rights reserved. No parts of this site may be used or copied without prior consent.

HARD WIRED LOW VOLTAGE HAND CONTROL CORDS
HOME / ABOUT US / PARTS / SERVICE / RETURN POLICY
On most hand controls the cords are permanently attached insuide the control and cannot be detached. If the cord gets damaged, you must replace the whole hand control unit. On a few of the ocntrols the cord will unplug from the bottom of the control. On these units you can replace just the cord if it gets damaged. When a hand control goes bad, usually just one button does not function and the rest are ok. When the cord is bad, usually nothing will operate. If you are not sure if it is the cord or the control itself tht is bad there is one thing you can try that may help to determine which it is. Hold the control in one hand with the head up button depressed. Grasp the cord just below where it comes out of the control and wigggle it around. If the motor starts and stops, it is usually the cord that is bad. If that does not change anything then the control itself is usually bad.
________________________________________________________________________________________
BETA-RAVEN FOR THE E SERIES ONLY
image
IFor use with the E-Series hand wands only. It is reinforced at the end that plugs into the hand control. The reinforce end on this plug does not allow it to be used in the 810, 812, Bronze or Silver hand wands. These cords are 8-9 feet long and are pre-made at the factory so they are only available in that length.
DISCONTINUED - YOU MUST USE THE SIX CONDUCTOR CORD BELOW
________________________________________________________________________________________
For use with the E-Series hand controls plus the Model 810, 812, Bronze and Silver hand controls, plus some other off brands. It is made without the reinforced end. This cord is normally approximately nine feet long but it can make it in any length, up to 15 feet long, at no extra charge. This can be helpful if you have a full or queen bed. The plugs on the end of this cord are arranged two ways - 810 BRLV Model and Titanium Model. (SEE DIAGRAM AT RIGHT TO DETERMINE WHICH ONE YOU NEED)
image
image
$20
SIX CONDUCTOR NON REINFORCED CORD
To determine if you need the 810 Model or the Titanium model cord , place each end of the cord nose to nose like two snakes looking at each other, with the clips up. If the color of the wires in the plug are the same across from each other, you need the 810 cord. If the color of the wires in the plug are the reverse of each other, you need the Titanium cord. It does not matter what color the wires are, just what order they are in.

We use cookies to enable essential functionality on our website and analyze website traffic. For more information, read our Cookies and Privacy Policy.

Your Cookie Settings

We use cookies to enable essential functionality on our website and analyze website traffic. For more information, read our Cookies and Privacy Policy.

Cookie Categories
Essential

These cookies are strictly necessary to provide you with services available through our websites.

Analytics

These cookies collect information that is used in aggregate and in an anonymized form to help us understand how our website is being used and how effectively our site is performing.