Copyright 2011-2026 All rights reserved. No parts of this site may be used or copied without prior consent.
HAND CONTROL "Y" CABLES
HOME / ABOUT US / PARTS / SERVICE / RETURN POLICY
When you have two hard wired bases under a king mattress and want them to move as a single unit, you need to use a Dual Motor Control Cord. Different brands use different type cords.
OKIMAT MOTOR Y CABLE
This cable is for use with the oki/richmat motor with a wired hand control. It has two male ends and a female end. The two male ends plug into one of the motors. Your existing hand control plugs into the female end. It can also be used as an extension cable for the hand wand.
$90
________________________________________________________________________________________
E SERIES Y CABLE
This junction cable is for use with any bed that uses the E-series or 810/titanium hand controls. It consist of the 2-1 splitter and two 810/titanium cords. The two included cords go from the splitter to the junction box under each base. You use the existing cord from your hand contol to plug into the single side of the splitter and into your hand control.
$60
$60
________________________________________________________________________________________
LINAK Y CABLE
The hand control cable is hard wired into the Linak hand control so it cannot be changed by itself. This cable though can be used to extend the length of the original control cable on queen and one piece king bases. The cable plugs into the control box, then you attach the splitter and then plug the hand control into the splitter. You will need to secure the connection at the splitter so it does not get pulled apart.
$80