Copyright 2011-2026 All rights reserved. No parts of this site may be used or copied without prior consent.
INPUT CORDS
HOME / ABOUT US / PARTS / SERVICE / RETURN POLICY
The "input cord" is the cord between the power supply and the junction/control box. Most cords have the same plug on the end that goes into the power supply, a flat flat and a tiny pi, It is the plug on the end that goes into the control unit that varies by manufacturer. If you have a manufacturer and serial number for your base I can check with my suppliers to determine the correct cord. If you do not know who's base it is, then I need to know what the plug on the power supply and the plug on the control/junction box looks like. I can then match it to one of the cords below.
________________________________________________________________________________________
OKIN/KEESON INPUT CORD
Used on most Okin and Keeson control units.
$35
$35
________________________________________________________________________________________
This is the extension cord for the Okin?Keeson input cord. It is used when your wall plug is too far away for the normal input cord to reach.
$35
$35
HHC/MOTOSLEEP INPUT CORD
This cord is used with the CB11, CB18, and CB20 control units.
$30
$30
________________________________________________________________________________________
RICHMAT INPUT CORD
On most of the Richmat control units the input cord is built in, but not all.
$50
$50
________________________________________________________________________________________
LINAK INPUT CORD
$ 85
________________________________________________________________________________________
ERGO HEAVY DUTY CORD
$ 35